The short answer
Assess the Damage First
Before you pull up anything, find where the water came from and stop it. Turn off the water supply if a pipe burst, or move items away from a leaking appliance. Then check how much flooring is wet. Look for discoloration, warping, or soft spots that signal deeper damage.
If water sat for more than a day or two, mold may already be forming. That changes the situation because you might need to remove more than just the top layer. If you are unsure about the extent, call the pros to inspect. They can test moisture levels in the subfloor and walls.
- Take photos of the damage for your records
- Check if the water is clean, gray, or black
- Look for swollen baseboards and buckled planks
- Feel for dampness in the subfloor
- Ventilate the room by opening windows
- Keep pets and kids off the wet area
Remove Carpet and Padding
Carpet and padding are usually the easiest to remove. You can cut the carpet into strips with a utility knife and roll it out. The padding underneath is often glued or stapled, so you can peel it up in sections. Wear gloves and a mask because wet carpet can hold bacteria and mold spores.
Dispose of the padding right away; it rarely dries well and can harbor mold. Carpet might be salvageable if the water was clean and dried quickly, but most pros recommend replacing both. If you keep the carpet, you still need to disinfect the subfloor thoroughly before installing anything new.
Handle Hardwood and Laminate
Hardwood and laminate react differently to water. Laminate usually swells and separates at the seams, making it hard to dry without damage. You can often pull up laminate planks by prying the baseboards and lifting the edges. Hardwood may cup or buckle, but sometimes it dries flat again if the water is clean.
If the hardwood is nailed down, you may need a pry bar and a lot of patience. Removing planks can damage the tongue and groove, so plan to replace entire sections. For both materials, check the subfloor for moisture. The pros can use drying equipment to save some areas, but warped boards usually need replacement.
Deal with Tile and Vinyl
Tile and vinyl are more water-resistant, but water can seep underneath through cracks or edges. Vinyl sheets may lift and trap water underneath, causing the adhesive to fail. You can peel back vinyl and dry the floor, but if the subfloor is wet, you might need to remove the entire sheet.
Tile is harder to remove because it can crack and leave behind mortar. You may need a chisel and hammer to break it up, which is labor-intensive. If the tile is intact and the grout is sealed, drying might be enough. But if water got under the tile, the subfloor could rot, so call the pros to check.
Dry the Subfloor and Prep
After removing the damaged flooring, the subfloor must dry completely before you install anything new. Use fans, dehumidifiers, and open windows to speed up the process. You can check dryness with a moisture meter, which you can rent or buy at a hardware store.
If the subfloor is wood, look for dark stains or a soft feel that indicates rot. You may need to replace sections of plywood or particleboard. Once everything is dry and clean, you can prepare the surface for new flooring. If you are unsure, the pros can handle the removal and drying.
Water damage does not wait
Call (949) 710-3360 any time, day or night, and describe what happened.
Call Now (949) 710-3360Frequently asked questions
Can I save any water-damaged flooring?
Sometimes. Clean water that dries within a day or two may leave carpet or hardwood usable, especially if the subfloor stays dry. But if water sat longer or was contaminated, replacement is safer. The pros can test moisture levels and tell you what is salvageable.
How long does wet flooring take to dry?
Drying can take a few days to a week, depending on the material, humidity, and airflow. Carpet padding may dry faster, but hardwood can take longer. Using fans and dehumidifiers helps. If mold appears, you need to remove the material and address the problem quickly.
Do I need to remove the subfloor too?
Not always. If the subfloor is solid and dries completely, you can keep it. But if it feels soft, shows dark stains, or has a musty smell, replace it. Water can soak into seams and cause rot. The pros can assess the subfloor and recommend the next steps.